29.01.2007, 19:17
Hello everybody,
I have a question regarding Headset for my NOKIA 6100. Do you mind if I'm asking in English since I'm not fluent in German?
I even don't know in which forum this post should go.
I'm using my mobile for long conference calls. I'm normally using the Nokia HS-5 headset but it is not the most confortable solution.
So, I started to look for other solutions on the web and I found this:
http://www.sjtelecommunications.com/pla-wta-nk610.html
This small adapter available in the USA allows to use any Plantronics headset with 2.5mm jack.
I'm working for a US compagny and asked a colleague to buy it for me to avoid shipping cost and taxes.
But the connector doesn't match my phone. The 6100 series means some old phone such as 6120, 6160 sold in the US. It's a 7 pins connector
The Nokia 6100 is using the 14 pins Pop-Port connector.
So, I'd like to merge both worlds and interconnect the cable of the HS-5 on this small adapter
Is somebody aware of the pinout specifications for this 7 pins connector to map correctly the microphone and speaker on it?
Thank you in advance
Bob
I have a question regarding Headset for my NOKIA 6100. Do you mind if I'm asking in English since I'm not fluent in German?
I even don't know in which forum this post should go.
I'm using my mobile for long conference calls. I'm normally using the Nokia HS-5 headset but it is not the most confortable solution.
So, I started to look for other solutions on the web and I found this:
http://www.sjtelecommunications.com/pla-wta-nk610.html
This small adapter available in the USA allows to use any Plantronics headset with 2.5mm jack.
I'm working for a US compagny and asked a colleague to buy it for me to avoid shipping cost and taxes.
But the connector doesn't match my phone. The 6100 series means some old phone such as 6120, 6160 sold in the US. It's a 7 pins connector
The Nokia 6100 is using the 14 pins Pop-Port connector.
So, I'd like to merge both worlds and interconnect the cable of the HS-5 on this small adapter
Is somebody aware of the pinout specifications for this 7 pins connector to map correctly the microphone and speaker on it?
Thank you in advance
Bob